Material: Mild Steel, CR, AL, Stainless, Non-Ferrous Material Width: 24" (26" untrimmed) Thickness Range: 0.005" - 0.040" Line Speed: 1000 FPM Line Direction: Right to Left
Consisting of the following:
-Entry Coil Car: Low Profile Design Narrow Coil Stabilizers Self Contained Hydraulics Pendant Control
-Uncoiler: Hydraulic Expansion 4 Segment Mandrel 16" - 20" Coil I.D. Range Maximum Coil O.D.: 63" Sliding Base 50 HP DC Motor, 500/2000 RPM, 500V Powered Holddown Roll Rubber Covered Roll with Banding Slot Paper Rewinder
-Driven Pinch Roll Unit: 18" Diameter Rolls Exit Catenary Rolls 15 HP DC Motor, 1150/2000 RPM
-Precision Slitter Heads: Model #146 (2) Injector Heads Entry Catenary Rolls Entry Side Guides 4.125" Dia. Arbors Steel Stripper Ring Assembly Exit Passline Rolls Exit Catenary Rolls 60 HP DC Motor, 1500/2000 RPM, 500V
-Injector Head Shuttle Base:
-Looping Pit Threading Table:
-Tension Stand: Combination Drag and Roll Type Entry Catenary Rolls Entry Separator Tooling Bar Entry Passline Roll Entry Wiper Drag Wipe Section with Air Bladder 3M Tension Rolls Each Roll Driven by 30 HP DC Motor Passline is adjustable by Laser guide. Tensioners adjust vertically as Coil O.D. increases on Recoiler to maintain a constant Passline. Threading Table to Recoiler
-Recoiler: 16" Dia. Drum Manual Clamp & Expansion Max. Coil O.D.: 63" Hydraulic Pushoff Overarm Separator Assembly (Attached to Tension Stand) Coil Clamping Arm 60 HP DC Motor, 500/2000 RPM, 500V
-Exit Coil Car: Low Profile Design Narrow Coil Stabilizers Self Contained Hydraulics Pendant Control
-Slitter Tooling: (2) Sets of Shimless Tooling
-Main Operators Control Panel:
-Hydraulic Power Unit:
-Removed and in Storage
Note: Original Line cost was $3,000,000. in 2000. Line only was in production for short time.
Your machine has been added to the Cart.
Click the Checkout button below or continue adding machines to the Cart.
Shopping Cart Help
To Add A Machine: While viewing the specifications of a machine, click "Add Machine to Cart".
To Submit Your Request: Click on "Checkout", then fill out the form with your contact information, and click "Submit".
To Remove A Machine: Click on "Checkout", then click the "Remove" button next to the machine you wish to remove from your Shopping Cart.